Four Rope Galvanized Steel Cable Barrier Highway Guardrail Median System for Flexible Road Safety
Product Details
| System Type: | Four Rope Flexible Cable Barrier | Rope Construction: | 3x7 And 1x19 Galvanized Strand |
|---|---|---|---|
| Rope Diameter: | 19mm | Post Type: | Cable Barrier Post With Cap And Rope Slots |
| Post Spacing: | 2400mm / 3200mm | Zinc Coating: | Hot Dip, Min 600 G/m2 On Steel Parts |
| Anchorage: | Ground Anchor And End Terminal Assembly | Tension Range: | 8-15 KN Per Rope At Installation |
| Standard: | AASHTO M180, EN 1317 Flexible System Geometry | ||
| Highlight |
Four Rope Cable Barrier,Galvanized Steel Highway Guardrail,Median System Cable Barrier |
||
Product Description
The four rope cable barrier system is a flexible, high tension safety barrier for motorway medians, bridge edges and dual carriageway separations where a rigid rail would be too heavy, too visually dominant or too hard to repair. Galvanized wire ropes are threaded through slotted posts and anchored at both ends; on impact the ropes deflect, absorb energy and redistribute load along the line, guiding the vehicle back toward the carriageway with a gradual deceleration instead of a hard stop.
Key Features- Four rope configuration: two pairs of ropes at different heights contain both passenger cars and higher centre of gravity vehicles, closing the underride gap that single level systems leave open.
- Energy redistribution: impact load spreads to many posts along the barrier line, so a single hit rarely damages more than a short section and repair usually means rope re-tension rather than full replacement.
- Low visual footprint: the open profile preserves sight lines and daylight on the median, which matters for landscaping approvals and for drivers on the opposite carriageway.
- Lightweight installation: no concrete pour or crane is needed for most sections, and posts can be driven or set in small footings, cutting installation time on narrow medians with live traffic either side.
- 600 g/m2 galvanized parts: all posts, brackets and anchor components are hot dip galvanized, and the rope is zinc coated strand for consistent corrosion performance in coastal and salt-treated road environments.
- Serviceable tension: rope tension can be checked and reset from the shoulder with standard tensioners, so routine maintenance needs no full lane closure.
| Parameter | Specification |
|---|---|
| System type | Four rope flexible cable barrier |
| Rope diameter | 19mm galvanized strand |
| Rope construction | 3x7 and 1x19, zinc coated |
| Rope height levels | Two pairs, typically 500mm and 750mm |
| Post spacing | 2400mm or 3200mm |
| Post type | Slotted cable post with cap, driven or footed |
| Zinc coating | Hot dip, minimum 600 g/m2 on steel parts |
| Installation tension | 8-15 kN per rope after settling |
| Anchorage | Ground anchor and terminal end assembly |
| Standard | AASHTO M180 components, EN 1317 flexible geometry |
Typical installations are motorway and expressway medians, bridge and viaduct edges where a rigid parapet is too heavy for the structure, dual carriageway separations on rural routes, and sections above embankments or water where a vehicle must not leave the road. The system also suits temporary and staged construction layouts, because sections can be extended, shortened or relocated as the traffic management plan changes.
Packaging & Quality AssuranceWire rope is supplied on steel reels with length and tension data marked on the flange, posts are bundled by type and length, and anchorages, brackets, tensioners and caps are crated in kits matched to each barrier section so that one crate plus one reel completes a defined length of line. All bundles and crates carry section marks that match the layout drawing.
Each production lot is checked for rope diameter and strand integrity, post slot position and coating mass, and anchor assembly weld quality. Tension test data and zinc mass reports are issued with the shipment, together with an installation sheet showing rope routing, torque values and the tension to apply at handover. Third party inspection and pre-shipment photography are available on request.
Product Highlights
Four rope cable barrier system with galvanized wire ropes, hot dip galvanized posts and anchorage assemblies for median and bridge edge protection.
Hot Dip Galvanized Steel Grating Checkered Plate Compound Heavy Duty Grating
Hot Dip Galvanized Composite Steel Grating | Checkered Plate Compound Grating Product Overview Hot Dip Galvanized Composite Steel Grating is a high-performance sealed steel flooring and drainage solution combining a welded steel grating base with a galvanized checkered anti-slip plate through full ...
Hot Dip Galvanized Q235 Steel Two Wave Guardrail AASHTO M180 Road Safety Guardrail
Hot Dip Galvanized Q235 Steel Two Wave Guardrail AASHTO M180 Road Safety Guardrail Galvanized W-beam Guardrail Two Wave Guardrail, also known as Double Wave W Beam Guardrail, is a semi-rigid traffic safety barrier widely used for highways, roads, bridges, ramps, parking lots and scenic areas. It is ...
Progressive Beam Lowering Terminal End Section with Deformable Energy Absorption and Left Hand or Right Hand Directional Build for Thrie Beam Guardrail
Energy absorbing terminal end section for thrie beam guardrail, cold roll-formed and galvanized, lowers the beam to ground level at the barrier run-out.
Please use our online inquiry contact form below if you have any questions, our team will get back to you as soon as possible.